Philips FW798W - Manual (Page 15)

15
English
Dolby Surround
This setting is for a full Dolby Surround Pro
Logic mode.
• Press DPL to select the Dolby Surround
mode.
™ The message
“ DOLBY
SURROUND”
will be
displayed.
™ The DPL display
panel will light
up.
Dolby Center Phantom
This setting is for use without the center
speaker. It redistributes the center speaker
sound to the left and right speakers,
providing conventional stereo across the
front.
• Press DPL to select the Dolby Pro Logic
Center Phantom mode.
™ The message
“ CENTER
PHANTOM”
will be
displayed.
™ The DPL display
panel will light
up.
Dolby 3 Stereo
Use this setting when full surround is not
required, but a wide stereo sound is
desired. It only requires the left, right and
center speakers.
• Press DPL to select the Dolby 3 Stereo
mode.
™ The message
“ DOLBY 3
STEREO”
will be
displayed.
™ The DPL display
panel will light
up.
Normal Stereo
This setting is for normal stereo sound
without Dolby Pro Logic. It only requires the
left and right speakers.
• Press DPL to select the Stereo mode.
™ The message
“ STEREO”
will be
displayed.
™ The DPL display
panel will light
up.
DOLBY PRO LOGIC
S S
L R
C
PRO LOGIC
S S
L R
C
PRO LOGIC
S S
L R
C
PRO LOGIC
S S
L R
C
PRO LOGIC
DPL M
BALANCE
L R
7 Adjust the sound of all the speakers
until they are equal. When you are
satisfied with the setting, press TEST
TONE again to switch off the test
signal.
Note:
– It is advisable to set the speakers’ level
at normal listening level. "XX" denotes
the sound level.
When you have completed the Dolby Pro
Logic setup, you are ready to enjoy Home
Cinema sound.
• Press DPL (PRO
LOGIC) repeatedly to
select and cycle through
the various sound
modes.
Dolby Surround ™ Center
Phantom ™ Dolby 3 Stereo ™
Stereo ™ Dolby Surround …
™ The Dolby Pro Logic display panel
will light up with the selection.
Important!
1 For the best Dolby Pro Logic sound,
switch on DPL with DSC set to
“Classic” and with Incredible
Surround off.
2 Dolby Pro Logic mode will
automatically switch to normal
Stereo mode when headphones are
connected.
3 Switch to normal stereo mode when
you record on a tape.