Functional description carton contents – Porter-Cable N066288 User Manual
Page 5
5
EXTENSION CORDS
Use proper extension cords. Make sure
your extension cord is in good condition and is a 3-wire
extension cord which has a 3-prong grounding type plug
and matching receptacle which will accept the machine’s
plug. When using an extension cord, be sure to use one
heavy enough to carry the current of the machine. An
undersized cord will cause a drop in line voltage, resulting
in loss of power and overheating. Fig. D-1 shows the
correct gauge to use depending on the cord length. If in
doubt, use the next heavier gauge. The smaller the gauge
number, the heavier the cord.
Fig. D-1
MINIMUM gAUgE EXTENSION CORD
RECOMMENDED SIZES FOR USE WITH STATIONARY ELECTRIC MACHINES
Ampere
Total Length
gauge of
Rating
Volts
of Cord in Feet
Extension Cord
0-6
120
up to 25
18 AWg
0-6
120
25-50
16 AWg
0-6
120
50-100
16 AWg
0-6
120
100-150
14 AWg
6-10
120
up to 25
18 AWg
6-10
120
25-50
16 AWg
6-10
120
50-100
14 AWg
6-10
120
100-150
12 AWg
10-12
120
up to 25
16 AWg
10-12
120
25-50
16 AWg
10-12
120
50-100
14 AWg
10-12
120
100-150
12 AWg
12-16
120
up to 25
14 AWg
12-16
120
25-50
12 AWg
12-16
120
gREATER THAN 50 FEET NOT RECOMMENDED
FOREWORD
The PORTER-CABLE PC400AP will connect to woodworking machines that accept a 4" diameter hose. This model PC400AP comes
with one 5 micron upper bag, one lower plastic bag and a 4" x 5 ft. collection hose.
NOTE: The picture on the manual cover illustrates the current production model. All other illustrations contained in the manual are
representative only and may not depict the actual labeling or accessories included. These are intended to illustrate technique only.
FUNCTIONAL DESCRIPTION
CARTON CONTENTS
1.
Motor and blower assembly
2.
Base
3.
Wheel casters (4)
4.
Side support (2)
5.
Upper bag
6.
Lower bag
7.
Filter bag clamp (2)
8.
Support
9.
Support rod base
10.
Support rod
11.
Hose
12.
Hose clamp (2)
13.
5/16-18 x 5/8" Hex head screw (12)
14.
5/16 Lockwasher (12)
15.
5/16-18 Hex nut (9)
16.
3/8 Lockwashers (4) for casters
17.
3/8-16 Hex nuts (4) for casters
18.
#8 x 1/2" Countersunk Screws (4)
for attaching dust hose inlet port
19.
Intake adapter
20.
Switch toggle
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20