Peavey TRANSTUBE 110 EFX - Manual (Page 5)

5
FEATURES AND CONTROLS
(1) AC POWER CORD (Under chassis)
This line cord provides the AC power to the unit. Connect the line cord to a properly grounded AC supply. Damage
to the equipment may occur if improper line voltage is used. (See voltage marking on unit.) Never remove or cut
the ground pin of the line cord plug.
Note for UK only
If the colors of the wires in the mains lead of this unit do not correspond with the colored markings identifying the
terminals in your plug, proceed as follows: (1) The wire that is colored green and yellow must be connected to the
terminal that is marked by the letter E, the earth symbol, colored green, or colored green and yellow. (2) The wire
that is colored blue must be connected to the terminal that is marked with the letter N or the color black. (3) The
wire that is colored brown must be connected to the terminal that is marked with the letter L or the color red.
(2) REMOTE SWITCH CONNECTOR
This 8-pin DIN connector is provided for the connection of the PFC 3 footswitch (not included). The footswitch
cable should be connected before the amp is powered up. See the FOOTSWITCH section of this manual for
explanation of switch operation.
(3) HEADPHONE JACK
This stereo jack allows signal to flow to both sides of any stereo headset. A monaural headset may be used, but it
is not recommened.
(4) EFFECTS RETURN
Input for returning signals from external low-level effects or signal processing equipment.
(5) EFFECTS SEND
Output for supplying signals to external low-level effects or signal processing equipment.
(6) INPUT
Rear Panel
2
1 3 4 5