PYLE Audio PLVS7HM - Manual (Page 7)

Installation
Video 2 input (yellow)
Ground (black)
DC 12V power input (red)
Remote Contr ol r eplacing batteries
PULL OUT
PUSH
1) Always use new batteries when replacing the old set.
2)Do not attempt to charge, short-circuit, disassemble, heat or burn used batteries.
3)Battery replacement is necessary when remote control acts sporadically or stops
operating.
4)Do not drop, apply shock or step on the remote control
5)Do not spill water on the remote control
6) Do not place objects between the remote control and remote sensor.
7)Do not use remote controls for other equipments at the same time.
8)If the MONITOR does not operate even when operating the remote control from
a close range, it is time to replace the batteries (use CR-2025), refer to the label
on back of the basic control.
Video 1 input (red)
Power Cord
(Female)
4