Panasonic Sa-xr57 - Manual (Page 15)

15
RQT8552
Confirming audio output from speakers and adjusting volumes
Through these steps, you make sure each of the connected speakers makes audio output.
Adjust the output level from each speaker and the output level from the front speakers to achieve balance in the listening-
viewing position.
1
Select [SPEAKERS A].
Press
or
• If you select SPEAKERS B only, the test signal will not be output.
When using a BI-WIRE connection (á page 11)
Select “YES ” in “Setting bi-wiring connections” (á page 31).
Press or
2 Check the test signal output.
Press
• A test signal is output from one speaker at a
time for two seconds in the following order.
L → C → R → RS → SBR → SBL → LS → SUBW
or
L → C → R → RS → SB → LS → SUBW
(When you connect one surround back
speaker only)
• Speakers not connected (á pages 11 and 14)
and others manually set as absent
(á page 31) do not produce the test signal.
3 Adjust the volumes of front
speakers to the normal
listening level.
Press
Volume range:
-- dB (minimum), -79 dB
to 0 dB (maximum)
4 Select a speaker for
adjustment.
Press
and select a
speaker.
5 Adjust the volume of the
selected speaker.
Press
Repeat steps 4 and 5 to adjust the level
of each speaker.
Adjustment range:
-10 dB to +10 dB (Factory setting: 0 dB)
SUBW only:
MIN (minimum) ↔ 1 to 19 ↔ MAX (maximum)
(Factory setting:
10 )
• Only the adjusted speaker produces the test signal in steps 4 and 5.
Connected speakers start producing the test signal again in the
above order 2 seconds after both steps.
6 Stop the test signal.
Press
SPEAKERS
A
A
SPEAKERS
When only the SPEAKERS A
setting is selected
A B
SPEAKERS
When SPEAKERS A and SPEAKERS B
settings are selected
SPEAKERS
A
SPEAKERS
B
A B
SPEAKERS
BI-WIRE
TEST
L : Front left
C : Center
R : Front right
RS : Surround right
LS : Surround left
SBR : Surround back right
SBL :
Surround back left
SB : Surround back (If you connect
one surround back speaker)
SUBW : Subwoofer
How speakers are displayed
VOLUME
LEVEL
TEST
Befor
e pl
ayback
E
N
GL
IS
H