Panasonic NV-FJ720 - Manual (Page 5)

5
RF
OUT
IN
IN (AV1)
AUDIO OUT
OUT
VIDEO
AUDIO
R
L
R
L
3
1
2
To mains supply
Aerial Connector
TV Set (Not supplied)
Aerial (Not supplied)
Aerial Input
socket j
Aerial Output
socket k
RF
OUT
IN
IN (AV1)
AUDIO OUT
OUT
VIDEO
AUDIO
R
L
R
L
3
1
2
4
Aerial Connector
VIDEO IN
(Supplied)
To mains supply
TV Set (Not supplied)
Aerial (Not supplied)
Aerial Input
socket j
Aerial Output
socket k
AUDIO OUT i /
VIDEO OUT e
AUDIO IN
RF
OUT
IN
IN (AV1)
AUDIO OUT
OUT
VIDEO
AUDIO
R
L
R
L
Connection to a Stereo Amplifier
PLAYBACK
Stereo Amplifier (Not supplied)
(Not supplied) REC
AUDIO IN h AUDIO OUT f / g
Setting the Remote Control to Operate Your
TV
You can operate the TVs of the manufacturers listed below
with the remote control after setting it.
This setting procedure allows you to operate the TVs of some
manufacturers using the supplied remote control.
Preparation
– Set the VCR/TV switch E to [TV].
Operations
1 Find the manufacturer number of your TV while
referring to the following table.
2 While holding down the POWER button 1 , use the
Numeric buttons 2 to enter the manufacturer number.
This completes the settings for the TV manufacturer.
– Be sure to enter the number in two digits.
Example: 1
) 01
3 To confirm the correct settings were made, check
whether the TV can be operated properly.
– When a manufacturer has multiple numbers in the
following table, try entering other numbers if the TV
operations cannot be performed properly, and then
select the optimal number.
Notes:
– If you are using a Panasonic TV, this setting has already
been made, and so you do not need to perform the above
setting procedure. However, this remote control may not
work with some Panasonic TVs.
– Some TV models cannot be operated using this remote
control (including all TVs non-remote compatible).
List of TVs Compatible with the VCR’s Remote Control
[Brand] [Code]
Panasonic/National 01–04
SONY 05
TOSHIBA 06
JVC 07
HITACHI 08
MITSUBISHI 09, 10
SHARP 11
PHILIPS, SAMSUNG 12
NEC 13
SANYO 14
GOLDSTAR/LG 15, 16
SAMSUNG 17, 18
SANYO 19
Connections
This section shows you how to connect the VCR to an aerial,
TV, etc.
When the VCR is turned on after unpacking and
connecting the aerial cable and the mains lead, Plug in
Auto Tuning starts automatically.
Basic Connections
The following connections are required to record and play
back the video cassette through the TV.
Connection to a TV using the Audio/Video Input Socket
Set the RF output channel of the VCR to [ss] (RF OFF)
when the VCR is connected to the TV via the Audio/Video
cable. (See page 6.)