Pride Mobility Jazzy 1143 - Manual (Page 31)

31 Jazzy 1143
I X . O P T I O N S A N D A C C E S S O R I E S
Figure 18. Power Seat Connector Housing Figure 17. Power Seat Toggle Switch
POWER SEAT SWITCH CONNECTOR TOGGLE SWITCH
Your Jazzy power elevating seat can be activated by using the power seat toggle switch located close to your
joystick. See figure 17. The toggle switch connector plugs into the power seat connector housing. See figure 18.
CAUTION! Be sure you are on a flat, level surface before activating the power elevating seat.
To raise the power elevating seat, push the toggle switch forward. Releasing the toggle switch returns the switch to
its center (upright) position. To continue your lift, push the toggle switch forward again. Once the seat reaches its
highest extension, the lift action stops; you should continue to hear and/or feel the lift motor running. This is because
there is a clutch mechanism that allows the motor to continue running after the lift has reached its limit. This clutch
works at both the top and bottom extensions of the lift. In order to prolong the life of your lift mechanism, please do
not allow the motor to run more than a few seconds after the mechanism reaches the top or bottom limit. To return
the seat to its lowest position, pull the toggle switch toward you. Releasing it stops the motor. When returning to the
lowest position, always be sure that the mechanism has reached its lowest limit.
To use the swivel feature, locate the swivel lever under the seat. It is located on the opposite side of the joystick.
Push down on the lever and the seat can be swiveled 90 degrees.