Pride Mobility Revo - Manual (Page 38)

38
www.pridemobility.com Revo
I X . C A R E A N D M A I N T E N A N C E
WIRING HARNESSES
! Regularly check all wiring connections.
! Regularly check all wiring insulation, including the charger power cord, for wear or damage.
! Have your authorized Pride Provider repair or replace any damaged connector, connection, or insulation that
you find before using your scooter again.
PROHIBITED! Even though the scooter has passed the necessary testing requirements for
ingress of liquids, you should keep electrical connections away from sources of dampness,
including direct exposure to water or bodily fluids and incontinence. Check electrical
components frequently for signs of corrosion and replace as necessary.
ABS PLASTIC SHROUDS
! The front tiller shroud, front shroud, and the rear shroud are formed from durable ABS plastic and are coated
with an advanced formula urethane paint.
! A light application of car wax will help the shrouds retain their high gloss.
AXLE BEARINGS AND THE MOTOR/TRANSAXLE ASSEMBLY
These items are all prelubricated, sealed, and require no subsequent lubrication.
MOTOR BRUSHES
The motor brushes are housed inside of the motor/transaxle assembly. They should be inspected periodically for
wear by your authorized Pride Provider.
CONSOLE AND REAR ELECTRONICS
! Keep these areas free of moisture.
! Allow these areas to dry thoroughly if they have been exposed to moisture before operating your scooter again.
FUSE REPLACEMENT
In the event a fuse should cease to work:
1. Remove the fuse by pulling it out of its slot.
2. Examine the fuse to be sure it is blown. See figures 20 and 20A.
3. Insert a new fuse of the proper rating.
WARNING! The replacement fuse must exactly match the rating of the new fuse. Failure
to use properly rated fuses may cause damage to the electrical system.
Figure 20. Working Fuse Figure 20A. Blown Fuse (Replace)