Paradyne 6211 - Manual (Page 57)

3. Using the Web Interface
6210-A2-GB23-00 January 2005 3-29
Access Control (6211 Only)
Access control allows certain PCs to access the modem after the firewall is
enabled.
Access control is enabled on a WAN connection only if the firewall is enabled
globally (see
Firewall/NAT Services on page 3-18) and enabled on that WAN
connection.
To enable any of the Access Control features:
Procedure
1. From the Home screen, click on Advanced.
2. Under Advanced, select Access Control. The Access Control screen appears.
All Access Control rules have precedence over rules that were added via the
Port Forwarding page.
3. The Apply button will temporarily save these settings. To make the change
permanent, click on Tools and select System Commands. On the System
Commands page, click on Save All.
Figure 3-23. Access Control
Log Out
Click on Log Out to close the session.