Planar PL1711M - Manual (Page 7)

5
Height Adjustment Stand
To unlock the height adjustment feature of the stand, locate the
pin on the back of the stand column and turn the pin knob
counter-clockwise. (See fig.1-1 )
Figure 1-1
Tilt, Swivel and Pivot Rotation
The LCD Monitor is designed to have a tilt range of
-5°to +25°, a swivel range of -35°to +35°, and a 90°
pivot rotation.
(See fig. 1-2)
Figure 1-2
Warning
Do not force the LCD Monitor over its maximum viewing angle settings as stated above. Attempting this will result in
damaging the Monitor and Monitor stand. The monitor stand base may forcefully extend and cause injury. Raise
the monitor to its "Full Up" position before removing the monitor stand.
Connecting the Display
1. Power off your computer.
2. Connect one end of the signal cable to the LCD Monitor’s VGA
port or DVI port. (See Fig 1-5)
3. Connect the other end of the signal cable to the VGA port or
DVI port on your PC.
4. Make sure connections are secure.
Figure 1-5
Connecting the AC Power
1. Connect the power cord to the LCD Monitor. (See Fig. 1-6)
2. Connect the power cord to an AC power source.
Figure 1-6
Connecting the Audio Cable
1. Connect the audio cable to the “LINE OUT” jack on your PC's
audio card or to the front panel's “AUDIO OUT” jack of your
CD ROM drive. (See Fig. 1-7)
2. Connect the other end of the audio cable to the LCD Monitor's "
LINE IN " jack.
Figure 1-7
Setting Up the LCD Monitor
1. Make sure the AC power cord is connected to the LCD Monitor.
2. Turn on the LCD Monitor's power switch, located on the bezel of the monitor.