Service and adjustments – Poulan 193282 User Manual

Page 20

Advertising
background image

20

00667

Fuel Filter

Clamp

Clamp

IN-LINE FUEL FILTER
The fuel fi lter should be replaced once
each season. If fuel fi lter becomes
clogged, ob struct ing fuel fl ow to car bu -
re tor, re place ment is re quired.
1. With engine cool, remove fi lter and

plug fuel line sec tions.

2. Place new fuel fi lter in position in fuel line

with arrow pointing towards carburetor.

3. Be sure there are no fuel line leaks and

clamps are properly positioned.

CLEANING

• Clean engine, battery, seat, fi nish, etc.

of all foreign matter.

• Keep fi nished surfaces and wheels free

of all gasoline, oil, etc.

• Protect painted surfaces with au to -

mo tive type wax.

We do not recommend using a garden
hose or pressure washer to clean your
tractor unless the engine and transmis-
sion are covered to keep water out. Water
in engine or transmission will shorten the
useful life of your tractor. Use compressed
air or a leaf blower to remove grass,
leaves and trash from tractor and mower.

SERVICE AND ADJUSTMENTS

WARNING: TO AVOID SERIOUS INJURY, BEFORE PERFORMING ANY SER-
VICE OR ADJUSTMENTS:
1. Depress clutch/brake pedal fully and set parking brake.
2. Place motion control lever in neutral (N) position.
3. Place attachment clutch in “DISENGAGED” position.
4. Turn ignition key to “STOP” and remove key.
5. Make sure the blades and all moving parts have completely stopped.
6. Disconnect spark plug wire from spark plug and place wire where it cannot

come in contact with plug.

TRACTOR

MUFFLER
Inspect and replace corroded muffl er and
spark arrester (if equipped) as it could cre-
ate a fi re hazard and/or dam age.
SPARK PLUG(S)
Replace spark plug(s) at the beginning
of each mowing season or after every
100 hours of operation, whichever occurs
fi rst. Spark plug type and gap setting are
shown in “PROD UCT SPEC I FI CA TIONS”
section of this manual.

4. Immediately wipe up any spilled gasoline.

01

698

Suspension Arms

Retainer
Spring

Anti-Sway
Bar

Retainer Spring

Retainer Springs
(Both Sides)

Front Link

Electric Clutch Pulley

TO REMOVE MOWER
Mower will be easier to remove from the
right side of tractor.
1. Place attachment clutch switch in “DIS-

ENGAGED” po si tion.

2. Move attachment lift lever forward to

lower mower to its lowest position.

Defl ector Shield

3. Roll belt off electric clutch pulley.
4. Disconnect anti-sway bar from chas sis

bracket by re mov ing re tain er spring.

5. Disconnect suspension arms from rear

deck brackets by removing re tain er
springs.

Advertising