Promise Technology VTrack M-Class M300f - Manual (Page 13)

Step 6: Connect the Power
13
Figure 15.VTrak M300f/i and M200f/i front panel LED display
When boot-up is finished and the VTrak is functioning normally:
• Controller LED blinks green once per second for five seconds, goes dark for
ten seconds, then blinks green once per second for five seconds again.
• Power, FRU and Logical Drive LEDs display green continuously.
• Fibre Channel/iSCSI/SCSI LEDs flash green if there is activity on that
channel.
There are two LEDs on each Drive Carrier. They report the presence of power
and a disk drive, and the current condition of the drive.
Figure 16.VTrak M500f/i/p disk carrier LEDs
Power
FC/iSCSI/SCSI-2 Activity
FRU Status
Logical Drive Status
FC/iSCSI/SCSI-1 Activity
Controller Heartbeat
Disk Status
Power/
Activity