Promise Technology VTrack M-Class M300f - Manual (Page 14)

VTrak M-Class Quick Start Guide
14
Figure 17.VTrak M300f/i/p and M200f/i/p disk carrier LEDs
After a few moments the Power/Activity should display Green.
If there is no disk drive in the carrier, the Disk Status LED and the Power/Activity
LED will remain dark.
Step 7: Set IP Address with CLI or CLU
VTrak has a Command Line Interface (CLI) to manage all of its functions,
including customization. A subset of the CLI is the Command Line Utility (CLU), a
user-level interface that manages your VTrak via your PC’s terminal emulation
program, such as Microsoft HyperTerminal.
You will use the CLU to assign an IP address to the VTrak for WebPAM.
1. Change your terminal emulation program settings to match the following:
• Bits per second: 115200
• Data bits: 8
• Parity: None
• Stop bits: 1
• Flow control: none
2. Start your PC’s terminal VT100 or ANSI emulation program.
3. Press Enter once to launch the CLI.
4. At the Login prompt, type administrator and press Enter.
5. At the Password prompt, type password and press Enter.
At this point, you are in the CLI. You can continue using the CLI to make
network settings or you can switch to the CLU.
• CLI: Fibre Channel and SCSI Models (M500f/p, M300f/p, M200f/p)
(page 15)
• CLI: iSCSI Models (M500i, M300i, M200i) (page 15)
• CLU: Fibre Channel and SCSI Models (M500f/p, M300f/p, M200f/p)
(page 17)
• CLU: iSCSI Models (M500i, M300i, M200i) (page 19)
Disk Status
Power/Activity