PLUS Vision U5-732 - Manual (Page 33)

E-33
General Operation
Using the Presentation Timer
Note:
* The timer display will be closed while the menu or the quick menu is displayed, and while a message is displayed; however, the timer will
still be operating at such times. Also, the timer will not be displayed unless a signal is being input.
* While the presentation timer is being displayed, screen movement will not be possible in the zoom mode.
The presentation is given while checking the timer displayed on the
screen.
The gauge display allows the remaining time to be known at a glance.
(1) Press the TIMER button to show the settings display.
The display will close when an operation has not been made for about
10 seconds.
Press the CANCEL button to close the display immediately.
(2) Use the ̇ and ̈ SELECT buttons to set the time.
The setting contents are “Off” and from 10 to 60 minutes (in 10-minute
intervals)
Settings can also be made with the SELECT (
̇̈) buttons.
• Press the ENTER button to restart the timer. The timer will start
with the same time setting.
• Press the CANCEL button to close the timer display. The timer set-
ting will return to “Off”.
Moving the Position of the Timer Display
The SELECT (
̆̄̇̈) buttons on the remote control permit movement
within the movable range of the timer display.
(3) Press the ENTER button and start the timer.
• The display of the timer setting will close, the display of the timer
will appear and simultaneously the timer will start.
FREEZE MUTE
LASER
AUTO
VOL ZOOM
RGB VIDEO
R-CLICK/
CANCEL
QUICK MENU
STANDBY
Q
1 2
3 4
TIMER
ENTER
(1)
(2)
(3)
CANCEL button
Movable Range of the Timer Display
Gauge (Blue)
[Timer Display]
[Timer settings display]
The blue gauge indicates the remaining time. When the gauge
disappears,the time is up.
The gauge continues to be displayed when the timer is stopped.
When the remaining time is “0”
(Gray)