Prima MAGICARD ID Card Printer - Manual (Page 25)

Ultra Electronics Card Systems
Magicard Prima Driver Manual 25
SECTION 4.3 PRINTER SETTINGS
The “Printer Settings” tab enables the user to set the printing parameters e.g. Speed,
Temperature and Bend Remedy. The settings are shown in a user friendly manner
via the P.C for every printer connected to the SCSI bus.
So for example if two printers (XID 450’s) were connected to the SCSI bus two tabs
would show at the top of the page:
Printer SCSI ID : 2
Printer SCSI ID : 3 etc.
• Load from File
Select a profile currently loaded on the computer
• Save to file
Save a profile to the computer.
• From Printer
Get current settings from the printer.
• To printer
Send settings currently on the screen to the printer.
• Test Print
Produces an internal test card from the printer.
NOTE A PROFILE IS A FILE ON THE PC THAT CONTAINS SPECIFIC
PRINTER SETTINGS
Individual printers
attached to the
SCSI Bus.
Printer Settings –
see Section 8 for
descriptions
Printer Setting
Transfers
(described
below).