Protec PROTEK II SN - Manual (Page 9)

9
After the first measurement is taken, a number will appear
on the left side of the display along with the thickness
reading on the right. The number on the left indicates the
number of measurements that must be taken to complete
the current series for the CAM average. Thus, each time a
measurement is taken, the number on the left decreases by
one.
The CAM indicator on the top of the display will flash on
and off indicating that a CAM series is in progress.
When the final measurement of the series is taken, the
gauge will “beep” then the CAM average is display on the
right and the average symbol “
<X> “ on the left and the
CAM indicator stops flashing.
To begin another series with the same number of
readings, just begin measuring. This process can be
repeated as many times as desired.
To begin another series using different number of
readings, repeat the step 1 to step 3.
Turning off CAM Mode
1- Enter into CAM mode. “ CAM MODE ” appears on
the display.
2- Press the key. “ CAM OFF ” appears on the
display.
3- Press the ON key. “-- -- --” will appear on the display
and the CAM indicator disappears.
Exit CAM Mode
1- Enter into CAM mode. “ CAM MODE ” appears on
the display.
2- Press the key. “ CAM OFF ” appears on the
display.
3- Press the key again. “ CAM EXIT ” appears on
the display.