Pella Sliding Patio Door V981553 - Manual (Page 8)

G. To snap the sill track in, place an 8" long 2" x 4" block on edge and begin tapping it from one
end with a rubber mallet until the track snaps into its original position.
INSTRUCTIONS (REVERSING DOOR SLIDE)
Note: Doors with Blinds-Between-the-Glass are not reversible.
F. Go to steps 3 and 4 to install the door frame into the opening. Then install the sill track before
proceeding to step 5.
Note: At the sill, it is imperative that sealant be applied under the screw heads and that it
surrounds them to prevent water leakage.
A. Remove the sill and screen tracks from the door.
(Use an allen wrench or small hook to begin removal.)
INSTALLATION INSTRUCTIONS (BOTTOM FIN REMOVAL) (continued)
B. Rotate the main frame 180° (so the sill becomes the head).
Snap the sill and screen tracks into place at the bottom of the
door. Carefully lay the panel on saw horses or a clean surface.
C. Extend the lock hook and clamp the lock hook with
the vise grip.
Note: Use of the vise grip on the lock hook will
prevent the mortise lock from falling when the lock
mounting screws are removed.
D. Remove the door handle by removing the two
attachment screws.
E. Remove the mortise lock. Remove the two screws
that attach the lock assembly to the door panel.
Work the lock down, then tilt it out and pull up.
Lock hook
C
Latch
lever
Backplate
D
.PSUJTF
MPDL
О
£
У
F. Rotate 180° and reinstall the lock. Insert the mortise lock into
the door panel with the lock adjusting screw positioned at the
bottom, then tilt the top in and lift the lock into position. Insert
the two mounting screws into the lock mounting holes. -PDL
BEKVTUJOH
TDSFX
.PVOUJOH
TDSFXT

4MJEF
QBOFM 
G. Rotate the handle 180° and install the door handle by
inserting the two backplate screws through the door panel
and into the exterior handle.
Note: Rotating the handle will result in "Pella" script
being upside down. A new handle must be ordered for
"Pella" to be in correct orientation.
Note: The latch lever must engage the slot in the side of the
mortise lock assembly.
H. Remove the bottom rollers from the slide panel by removing
the upper screw. Reinstall the rollers in the opposite end of
the door panel.
I. High Performance Doors only: Remove the blocks from the
top rail of the door panel and reinstall them at the opposite
end of the panel.