Planet Technology Wireless USB Adapter WL-U350 - Manual (Page 16)

communication is done from client to client without the use of an Access Point.
Channel: Shows the number of the radio channel used for the networking. Only Access
Points and Ad-Hoc nodes create the BSSID. This parameter is not active in the
infrastructure operation mode.
SSID: Shows the SSID of the BSS that one willing to join.
Tx Rate: Shows the Data Transfer Rate. There are 1 Mbps, 2M bps, 5.5 Mbps, 11 Mbps,
and auto mode. If Auto Mode is been selected, the device will select the most suitable rate
automatically.
Power Mgmt Mode: Shows Power Management modes. There are two optional
selections for this mode.
Active-- Adaptor will always set in active mode.
Power Save -- Adaptor will enter power saving mode when it is idle.
Signal Strength: This bar shows the signal strength level. The higher the blue bar, the
more radio signal been received by the Wireless USB adaptor. This indicator helps to find
the most comfortable antenna/workstation position for quality network operation.
Link quality: The measured Signal Strength level gives the overall Link Quality and
Connection Status.
MAC Address: The MAC Address of the Wireless USB Adaptor. Unique 48-bit,
hard-coded Media Access Control address known as the station identifier.
3.2 "Statistics"
Show the total amounts of packets been received or transmitted by the adaptor.
Data Field: Shows the total amounts of data packets been successful/unsuccessful
transmitted or received by the adaptor..
Management Field: Shows the total amounts of management packets been successful /
unsuccessful transmitted or received by the adaptor.
Rejected Packets Field: Shows the total amounts of rejected packets been transmitted
or received by the adaptor.