Poulan Pro PP5000P - Manual (Page 4)

4
S Use only a voltage supply as shown on the
nameplate of the unit.
S Avoid dangerous situations. Do not use in
presence of flammable liquids or gases to
avoid creating a fire or explosion and/or
causing damage to unit.
S Avoid dangerous environments. Do not use
in unventilated areas or where dust or ex-
plosive vapors can build up.
S To reduce the risk of electric shock, the pow-
erhead may have a polarized plug (one blade
is wider than the other); if so, it will require the
use of a polarized extension cord. The ap-
pliance plug will fit into a polarized extension
cord only one way. If the plug does not fit fully
into the extension cord, reverse the plug. If
the plug still does not fit, obtain a correct polar-
ized extension cord. A polarized extension
cord will require the use of a polarized wall
outlet. This plug will fit into the polarized wall
outlet only one way. If plug does not fit fully
into the wall outlet, reverse the plug. If it still
does not fit, contact a qualified electrician to
install the proper wall outlet. Do not change
the equipment plug, extension cord recep-
tacle, or extension cord plug in any way.
S To reduce risk of electrical shock, use exten-
sion cords specifically marked as suitable for
outdoor appliances having electrical rating not
less than the rating of unit. Cord must be
marked with suffix “W--A” (in Canada “W”).
Make sure your extension cord is in good
condition. Inspect extension cord before use
and replace if damaged. Do not use a dam-
aged cord. Cord insulation must be intact with
no cracks or deterioration. Plug connectors
must be undamaged. The extension cord
used to reach the power source must be
heavy enough to carry current from the power
source the full length of the extension cord to
the unit. An undersized extension cord will
cause a drop in line voltage resulting in loss of
power and overheating. If in doubt, use the
next heavier gauge. The lower the gauge
number, the heavier the cord.
S Do not use multiple cords.
S Do not abuse cord. Never carry the unit by
the extension cord or yank extension cord
to disconnect unit. To unplug, grasp the
plug, not the cord. Do not use cord as a han-
dle, close a door on cord, or pull cord
around sharp edges or corners. Do not ex-
pose cords to heat, oil, or water.
S Keep the extension cord clear of operator and
obstacles at all times.
S Tie cord to cord retainer and connect to re-
cessed plug as shown in this manual to pre-
vent damage to unit and/or extension cord
and to reduce the possibility of the exten-
sion cord disconnecting from the unit during
operation.
S Do not attempt to repair unit. Inspect the insu-
lation and connectors on the powerhead and
extension cord before each use. If there is
any damage, do not use until damage is re-
paired by your authorized service dealer.
S Do not use the powerhead if the switch
does not turn the unit on and off properly.
Have the unit repaired by your authorized
service dealer.
S Do not use with damaged cord or plug. If
powerhead is not working as it should, has
been dropped, damaged, left outdoors, or
dropped into water, return it to your autho-
rized service dealer for repair.
S Avoid unintentional starting of the unit. Nev-
er carry unit with your finger on the switch.
Be sure the switch is in the off position and
never touch the switch when connecting
extension cord.
S Unplug the unit from the power source when
not in use, before servicing, and when chang-
ing accessories and/or attachments.
S Avoid any body contact with any grounded
conductor, such as metal fences, or pipes,
to avoid the possibility of electric shock.
S Ground Fault Circuit Interrupter (GFCI)
protection should be provided on the circuit
or outlet to be used for the powerhead. Re-
ceptacles are available having built-in
GFCI protection and may be used for this
measure of safety.
UNIT/MAINTENANCE SAFETY
WARNING:
Disconnect powerhead
spark plug (or disconnect powerhead from pow-
er source) before performing maintenance.
S
Inspect entire unit before each use. Replace
damaged parts. Check for fuel leaks. Make
sure all fasteners are in place and securely
fastened.
S Maintain unit according to recommended pro-
cedures.
S Use only recommended Poulan PRO parts
and accessories.
S Be sure chain stops moving when engine
idles (see CARBURETOR ADJUST-
MENTS section of powerhead manual).
S Keep others away when making carburetor
adjustments.
S Never start the unit with the clutch housing re-
moved. The clutch can fly off and cause seri-
ous injury.
S Keep the handles driy, clean, and free of oil or
fuel mixture.
S Keep fuel and oil caps, screws, and fasteners
securely tightened.
S Have all maintenance and service not ex-
plained in this manual performed by an autho-
rized service dealer.
OPERATE YOUR PRUNER SAFELY
S Operate the pruner only in a well-ventilated
outdoor area.
S Do not use a pruner to cut down trees or any
portion of the tree trunk.
S Only use for pruning limbs or branches
overhead not greater than 6 inches (15 cm)
in diameter.
S Do not cut small brush and saplings with the
pruner. Slender matter may catch in the chain
and be whipped toward you, pulling you off
balance.
S Make sure the chain will not make contact
with any object while starting the engine.
Never try to start the unit when the guide
bar is in a cut.