Pioneer S-GX3V - Manual (Page 33)

Additional information 12
33
En
English
Français
Deutsch
Nederlands
Italiano
Español
Chapter 12
Additional information
Using the System Setup menu
A number of additional settings (listed below)
can be accessed by using the System Setup
menu. The first setting in each is the default.
1 If necessary, switch into standby.
This is necessary if you want to access the
System Setup menu options in standby below.
2 Press SYSTEM SETUP (SHIFT+HOME MENU).
3 Use / (cursor left/right) to choose the
setting then press ENTER .
The current setting is shown for each option as
you cycle through the display. See below for a
full list and description of each.
4 Use / (cursor up/down) to adjust the
setting then press ENTER to confirm.
5 Repeat steps 2 to 4 to make other settings.
System Setup menu options
These are all the available settings in the setup
menu when the system is switched on:
1
Dimmer setting
Sets the front panel display brightness level:
• LIGHT
• DARK
Tape deck beat cut setting
Recording AM broadcasts on cassette tape
can result in noisy recordings. If you
experience this, change the beat cut mode.
• B.CUT 1
• B.CUT 2
System Setup menu options in standby
Below are all the available settings in the setup
menu when in standby:
System demo setting
Switches the automatic demo feature on or off:
• ON – Switches the demo feature on.
• OFF – Switches the demo feature off.
Frequency step setting
Applicable to Singapore, Malaysia, Taiwan,
Indonesia and Philippines models only
If you find that you can’t tune into stations
successfully, the frequency step may not be
suitable for your country/region.
• AM 9K – AM 9kHz / FM50kHz
• AM 10K – AM10kHz / FM100kHz
TV system setting
The default setting of this system is AUTO , and
unless you notice that the picture is distorted
when playing some discs, you should leave it
set to
AUTO . If you find picture distortion with
some discs, set the TV system to match your
country or region’s system. However, this may
restrict the kinds of disc you can watch.
See the table for the kinds of discs compatible
with each setting ( AUTO , PAL and NTSC ). 2
Note
1 If the tuner is selected, the tuner options also appear (see Automatically saving station presets on page 17 and Manual tuner
features on page 25). Note that the beat cut setting only appears during AM reception.
2 Most models of the newly developed countdown PAL TV system detect 50 Hz (PAL)/60 Hz (NTSC) and automatically switch
vertical amplitude, resulting in a display without vertical shrinkage. However, in some cases, the image may appear without col-
or. If your PAL TV does not have a V-Hold control, you may not be able to watch NTSC discs because of picture roll. If the TV has
a V-Hold control, adjust it until the picture stops rolling. On some TVs, the picture may shrink vertically, leaving black bands at
the top and bottom of the screen.
XV-GX3.book 33 ページ ２００５年７月６日 水曜日 午前１１時４２分