Planet Technology GSW-2416SF - Manual (Page 23)

4.4.3.1 Set port [n]
This command allows configuring per port parameters of GSW-2416SF. the correct usage is shown as below:
Set port [n]: n=1-24, to configuring per port parameters of GSW-2416SF.
Default setting: (1) Auto Speed
The configuring per port parameters screen in Figure 4-18 appears and the detail description shown in table 4-2.
Figure 4-18 Port Configuration screen
guration screen Objects
lan [n]
This command allows configuring up to 24-port based VLAN Groups of GSW-2416SF. The correct usage is shown as
below:
Set vlan [n]: n=1-24, to configuring 24 VLAN Groups of GSW-2416SF. [n] is the VLAN Group ID. And the following
message appears:
Please input port number (1-24), exit press enters: Add/Remove port to the current VLAN Group, “*” means port had
been assign to the VLAN Group.
Default setting: none
The configuring VLAN Groups screen in Figure 4-19 appears. (Assign port 1, port 6 and port 7 to VLAN Group 1)
Object Description
(1) Auto Speed Setup Auto negotiation of each port.
(2) 10 Half Force sets 10Mbps/Half-Duplex mode for specific port.
(3) 10 Full Force sets 10Mbps/Full-Duplex mode for specific port.
(4) 100 Half Force sets 100Mbps/Half-Duplex mode for specific port.
(5) 100 Full Force sets 100Mbps/Full-Duplex mode for specific port.
(6) 1000 Full Force sets 10000Mbps/Full-Duplex mode for specific port.
(7) Disable Disable or Shutdown the specific port
Table 4-2 Descriptions of the Port Confi
4.4.3.2 Set v
EM-GSW2416SFv1 - 23 -