Paradyne 9788 - Manual (Page 155)

7. Operation and Maintenance
9700-A2-GB20-20 December 2002 7-19
System and Test Status Messages
To access System and Test status information:
Main Menu
→Status →System and Test Status
The following information is included on this screen:
Self-Test Results Messages
Last Reset
Health and Status Messages
Test Status Messages
NOTE:
Status messages in the following sections are in alphabetical order.
Self-Test Results Messages
Self-test result messages shown in Table 7-5, Self-Test Results Messages appear
in the Self-Test Results field at the top of the System and Test Status screen.
Last Reset
The Last Reset field provides the last date and time that the FrameSaver unit was
reset. This field is located after the Self-Test Results field at the top of the System
and Test Status screen.
Main Menu
→Status →System and Test Status
Table 7-5. Self-Test Results Messages
Message What It Indicates What To Do
Failure xxxxxxxx An internal failure occurred
(xxxxxxxx represents an
8-digit hexadecimal failure
code used by service
personnel).
Record the failure code
before resetting the unit;
otherwise, the error
information will be lost.
1. Record the failure code.
2. Reset the unit.
3. If problem still exists, contact
your service representative.
Passed No problems were found
during power-on. No action needed.