ProForm PFCCEX34390 - Manual (Page 5)

5
ASSEMBLY
Assembly requires two persons. Place all parts of the recumbent cycle in a cleared area and remove the pack-
ing materials. Do not dispose of the packing materials until assembly is completed.
Assembly requires the included tools and your own adjustable wrench and Phillips screw-
driver .
Use the part drawings below to identify the small parts used in assembly. The number in parenthesis below
each drawing refers to the key number of the part, from the PART LIST in the center of this manual. The second
number refers to the quantity needed for assembly. Note: Some small parts may have been pre-attached for
shipping. If a part is not in the parts bag, check to see if it has been pre-attached.
M6 Nylon Locknut (15)–4
M6 x 38mm Button Bolt (14)–7
M10 Nylon Locknut (45)–2
M10 X 75mm Carriage Bolt (72)–2
M10 x 25mm Button
Head Screw (74)–10
M8 Washer (20)–7
M6 Washer (22)–3
M8 x 38mm
Button Bolt (24)–4
M6 x 22mm
Button Screw (29)–4
M8 x 100mm Button Bolt (63)–3
M10 Split Washer (17)–10
M4 x 16mm
Screw (21)–6
Ground Screw (82)–1