Nikon HT1000 - Manual (Page 14)

E-14
PC CONTROL RGB IN DVI-D IN
SC TRIGGER
VIDEO IN S-VIDEO IN
S-VIDEO S-VIDEO RGB/DVI RGB/DVI VIDEO VIDEO AUDIO IN AUDIO IN COMPONENT
Y Cb/Pb Cr/Pr
VIDEO IN S-VIDEO IN
AUDIO OUT
R L
VIDEO OUT
S-VIDEO OUT
AUDIO IN
L R
VCR/ Laser disc player
Connecting Your VCR or Laser Disc Player
Audio equipment
S-video cable (supplied) Composite video
cable (supplied)
Audio cable (not supplied)
Use the supplied composite video cable to connect your VCR or laser
disc player to your projector.
To make these connections, simply:
1. Turn off the power to the projector and VCR or laser disc player.
2. Connect one end of the composite video cable to the video output
connector on the back of your VCR or laser disc player, connect the
other end to the Video input on your projector. Use an audio cable
(not supplied) to connect the audio from your VCR or laser disc player
to your audio equipment (if your VCR or laser disc player has this
capability). Be careful to keep your right and left channel connections
correct for stereo sound.
3. Turn on the projector and the VCR or laser disc player.
VIDEO AUDIO IN
or
S-VIDEO AUDIO IN
NOTE: Refer to your VCR or laser disc player owner's manual for more informa-
tion about your equipment's video output requirements.
NOTE: An image may not be displayed correctly when a Video or S-Video source
is played back in fast-forward or fast-rewind via a scan converter.
Audio cable
(supplied)