NAD T741 - Manual (Page 14)

GB
14
STORING AND RECALLING PRESETS
TO STORE A PRESET
• Tune to the radio station you wish to enter into a Preset (refer to
chapter “Front Panel Controls”; section 8). If the station is
transmitting RDS information, the RDS indicator will light up and
station initials will be shown in the Display Panel. If a non-RDS station
is found, then just the frequency will be shown.
• To store that station as a Preset, press MEMORY (No. 6). “MEMORY”
and the preset section in the display panel will start to flash. If no
other button is pressed within 10 seconds, “MEMORY” will stop to
flash and the receiver will default to its previous state.
• Press either the (down) or (up) button to select which
Preset number you wish to assign to the station (from 1 to 30 on FM
and 1 to 10 on AM), shown as a flashing number in the Display Panel,
and then press MEMORY (No. 6) again. The Memory light in the
Display Panel will go out and the station is now stored in your NAD
T741’s memory.
To exit the Memory mode without storing a station, leave all the tuner
controls untouched; the Memory mode will automatically cancel itself
after 10 seconds. The Memory Presets have a memory back-up, so they
will remain stored for several weeks even if the Receiver is switched off or
unplugged from the mains supply.
NOTE
You can enter a new station into an unused Preset or over-write an
existing programmed Memory Preset. By doing this you will replace
the radio station previously held on that Preset number.
RECALLING A PRESET STATION
To select a Preset station:
• Select the Preset mode by pressing the PRESET/TUNE button (No. 7)
until “PRESET” lights up in the display.
• Press either the (down) or (up) button (No. 8) until the
right Preset is found and shown in the Display Panel.
NOTE
Any unused Presets will be skipped.
To “Directly Access” a Preset Station from the Remote Control:
Press the numeric key on the Remote Control (AVR-1) the Preset number
selected flashes in the Front Panel display window for 2 secs allowing for
a valid second key entry for presets 10 and above.
DELETING A STORED PRESET
You can empty a Preset by deleting the stored information:
• Press MEMORY button (No. 6).
• Press DOWN/UP buttons (No. 8) to select the preset number to be
deleted.
• Press the FM MUTE/MODE button (No. 5). The Preset will then be
deleted and ‘—’ appears as the Preset number.
You can also store a new station into a used Preset, by simply going
through the Preset storing process and placing a new station over the
existing one.
REMOTE CONTROL AVR-1 (FIGURE 3.)
The T741 is supplied with the NAD AVR-1 Remote Control. Apart from
all the primary operating functions, the AVR-1 Remote Control handset
also gives access to functions not available on the front panel of the
T741. It also has additional controls to remotely operate NAD T550, L55,
T531 and T571 DVD Players. The function of the buttons will change
between the T741 Receiver and the NAD DVD Player depending on the
position of the RCVR/DVD switch (See 2
5 below). Shared buttons
(buttons that function with the switch in either position) have the
receiver function printed on the button itself, with the secondary DVD
function printed on the body of the remote handset
Alkaline batteries are recommended for maximum operating life. Two
AAA (R 03) batteries should be fitted in the battery compartment at the
rear of the Remote Control handset. When replacing batteries, check
that they have been put in the right way round, as indicated on the base
of the battery compartment. It will operate up to a distance of 16ft (5m).
1. POWER
Press this button to switch the unit from operating mode to the Stand-
by mode and vice versa:
Press this button again to switch the unit on from Stand-by; the last
selected source will be indicated in the display.
2. SLEEP
Press SLEEP to make the T741 automatically switch off after a preset
number of minutes. Pressing the SLEEP button once will set the sleep
time to 90 minutes, after which the T741 will automatically switch off
into Standby mode. Sleep mode is shown on the Display Panel. To adjust
the Sleep Delay, press the SLEEP button, each consecutive press will
reduce the sleep time in 30-minute increments, as shown in the Display
Panel. To cancel the Sleep mode, continue pressing the SLEEP button
until the sleep time returns to 0 minutes. Pressing the POWER on the
front panel (No.1) or POWER button on the remote control (No. 1) will
also cancel the Sleep mode.
3. INPUT SELECTION
The EXT 5.1, VIDEO 1 TO 5, TAPE MON, FM/AM and CD Input selector
buttons perform the same function as those on the front panel of the
T741.
T741 manual (GB) 22/10/01 3:56 pm Page 14