NEC DTR-IR-2 - Manual (Page 21)

B a s i c s [ 1 7 ]
Temporarily Muting the Ringer
You can mute the ringer on a handset. When the phone is ringing, pressing the MUTE soft key. This
mute will last for the current incoming call only. The ringer tone will return to the previous setting on the
next incoming call.
Mute Microphone
You can temporarily mute the microphone so that the caller cannot hear you.
Press the MUTE soft key during talk mode (while the phone is in use) to mute
the microphone.
M ut e O n and appear in the display. To cancel muting, press
the MUTE soft key again. M ut e Of f appears.
Tone Dialing Switch-over
If your telephone company requires pulse dialing, you can switch-over to tone
dialing after the call connects. This feature is useful when you need tone
dialing to use any automated menu systems, such as telephone bank tellers,
telephone prescription refills, customer support menus, etc.
If your phone is set to pulse dialing mode, make your call normally. Once your
call connects, press the
* /tone/ < key. Any digits you enter from then on will be
sent as tone digits. When this particular call ends, the phone automatically returns to pulse dialing
mode.
Traveling Out of Range
During a call, as you begin to move your handset too far from your base unit, noise may increase. If you
pass the range limits of the base unit, you will hear a beep and see
Ou t o f Ra ng e on the display, and
then the handset returns to standby mode.
Privacy Mode
Privacy Mode prevents interruption from other registered handsets. This works only when the phone
is in use.
Press the PRIVACY soft key on the handset during talk mode .
Priv acy Mode On and appear in the display. To exit the Privacy Mode, press the
PRIVACY soft key again when the Privacy Mode is on. Pr i va cy M od e O ff
appears.
While charging the handset, you can not mute the ringer tone for the handset.
note
6 C N M          ߦ

/76' 24+8#%;
     / W V G  1 P
6 C N M
2 T K X C E [  / Q F G  1 P
          
/76' 24+8#%;