Additional hdd cage – NEC Express 5800/230Eh User Manual
Page 260
Advertising
9-54 Upgrading Your Server
Additional HDD Cage
The N8154-09 additional HDD cage (called HDD cage) is dedicated to the server. It can contain
four SATA hard disk drives to configure a disk array. The hard disk drives can be removed or
replaced with the server being powered on (hot-swap feature).
Installation
Install the HDD cage in the following procedure.
1.
See the section "Preparing for Installation and Removal" described earlier to prepare.
2.
Remove the left side cover according to the section "Front Mask" described earlier in this
chapter and open the front mask.
3.
Disconnect the interface cable and power cord from the hard disk drive if connected.
4.
Remove two screws on the front panel securing the hard disk drive carrier.
Advertising