Nikon S1200PJ - Manual (Page 98)

80
U
sin
g
th
e Projec
tor
Using the Projector
Displaying Pictures with the Projector
Projecting Pictures
1
Place the camera.
• Place the camera on a stable and level surface such as a table.
• Point the projector window at a screen (available commercially) or flat white surface.
• The projection distance between the camera and screen should be approximately
26 cm (11 in.) to 3.1 m (10 ft) ( A 82).
2
Turn on the camera and open the
projector cover.
• The camera enters playback mode and pictures
stored in the internal memory or on a memory card
inserted into the camera are projected in full-frame
playback mode.
• To project pictures in favorite pictures mode, auto
sort mode, or list by date mode, follow the procedure in “Switching Between Playback
Modes” (
A 70) to switch the playback mode.
• The camera’s monitor turns off when the projector is in operation, and the multi
selector, the k button, and d button are backlit, making the camera easy to use in
the dark.
• The projector brightness is reduced immediately after the projector cover is opened,
and it increases to the normal level after about ten seconds.
3
Adjust the camera position.
• To change the projected picture size, adjust the distance between the camera and
screen.
• Adjust the projection angle to reduce picture distortion.
4
Adjust focus for the projected
picture.
• Turn off unnecessary lights.
• Rotate the projector focus dial to adjust
picture focus.
5
Press the multi selector
H, I, J, or K on the camera to change the
projected picture.
• You can also use the remote control (available separately) to change the picture
( A 4, 81).
• See “Projector Controls” (A 83) for more information about when the projector is in
operation.
6
Close the projector cover to end projection.
• Turn off the camera after closing the projector cover.