NCR S10XL - Manual (Page 141)

Sample Configurations
Sample RAID Configuration
NCR S10XL Hot Plug Server User Guide C-21
PCI Slot 1 [Disabled]*
PCI Slot 2 [Disabled]*
PCI Slot 3 [Disabled]*
System BIOS Type [E, F Segment...]
Peripheral Device Status
Mouse Port [Enabled]
Keyboard Port [Enabled]
Floppy Disk Controller [Enabled]
IDE HDD Interface [Disabled]
Parallel Port [Enabled as LPT1...]
Serial Port 1 [Enabled as Serial 1...]
Serial Port 2 [Enabled as Serial 2...]
System Setting
Special System Ports [Enabled]
EISA Reserved Device [Enabled]
If a PCI adapter is configured in the system,
change Disabled to the IRQ level for the PCI adapter
installed in the slot.
4. Exit and save the configuration.
Prior to installing the operating system, it is necessary
to use the Mylex Disk Array Configuration Utility to
configure the Array Group.
Refer to the Mylex Disk Array Controller User’s Manual
for detailed instructions.
*Note:
Configuring the Mylex
RAID Array Group