Chapter 3 configuration and troubleshooting, Understanding the configuration options, Understanding the configuration options -1 – NETGEAR GA311 User Manual
Page 31
3-1
v1.0, February 2007
Chapter 3
Configuration and Troubleshooting
This chapter describes how to use the advanced configuration options of your NETGEAR 10/100/
1000 Mbps Gigabit Ethernet Adapter GA311 and basic troubleshooting techniques.
Understanding the Configuration Options
The GA311 adapter provides the following advanced options:
•
Configure the 802.1Q VLAN ID. The IEEE 802.1Q standard defines the operation of Virtual
LAN (VLAN) Bridges that permit the definition, operation and administration of Virtual LAN
topologies within a Bridged LAN infrastructure.
•
Configure 802.1Q/1p VLAN tagging. The 802.1p Quality of service (QOS) is an OSI layer 2
standard for prioritizing network traffic at the data link sublayer.
•
Enable Jumbo frames to extend Ethernet frames to 7500 bytes
•
Set the link speed and the duplex mode:
–
Auto Negotiation
–
1000Mbps/Full Duplex
–
100Mbps/Full Duplex
–
100Mbps/Half Duplex
–
10Mbps/Full Duplex
–
10Mbps/Half Duplex
•
Set up checksum offloading to the network card
•
Set up the offload of TCP large packets to the network card
•
Enable wakeup on ARP/PING