NETGEAR FVS328 - Manual (Page 2)

4. R
UN THE
S
ETUP
W
IZARD TO CONNECT TO THE
I
NTERNET
a. You are now connected to the router. If you do not see the
menu above, click the Setup Wizard link on the upper left of
the main menu.
b. Choose NAT or Classical Routing. Typically, NAT is used.
NAT automatically assigns private IP addresses
(192.168.0.x) to LAN connected devices. Classical routing
lets you directly manage the IP addresses the FVS328 uses.
c. Click Next to proceed. Input your ISP settings, as needed.
d. At the end of the Setup Wizard, click the Test button to
verify your Internet connection and register your product. If
you have trouble connecting to the Internet, use the
Troubleshooting Tips below to correct basic problems, or
refer to the Reference Manual on the CD.
You are now connected to the Internet!
Troubleshooting Tips
Here are some tips for correcting simple problems that prevent with
you from connecting to the Internet or connecting to the firewall.
Be sure to restart your network in the correct sequence.
Follow this sequence. Turn off the modem, firewall, and
computer. Turn on the modem first and wait two minutes. Next
turn on the firewall, and finally the computer.
Make sure the Ethernet cables are securely plugged in.
•
For each powered on computer connected to the firewall with a
securely plugged in Ethernet cable, the corresponding firewall
Local port status light will be lit. The label on the bottom of the
firewall identifies the number of each Local port.
• The Internet port status light on the firewall will be lit if the
Ethernet cable from the firewall to the modem is plugged in
securely and the modem and firewall are turned on.
Make sure the network settings of the computer are correct.
LAN connected computers must be configured to obtain an IP
address automatically via DHCP, unless you have turned NAT
off and are managing the IP addresses directly. For instructions
on these configuration settings, please see the Reference Manual
on the Model FVS328 Resource CD.
Technical Support
Thank you for selecting NETGEAR products.
Register Your Product
To register, point your browser to this location:
http://www.NETGEAR.com/register
Go to http://www.NETGEAR.com/support to browse for additional
information. ©2003 by NETGEAR, Inc. All rights reserved.
NETGEAR is a registered trademark of NETGEAR, Inc. in the United States and/or
other countries.
Other brand and product names are trademarks or registered trademarks of their
respective holders. Information is subject to change without notice.
201-10082-01 December 2003