Niles Audio Personal Emergency Reporting System PERS-3600B - Manual (Page 4)

2
7. TRANSMITTER INSTALLATION OPTIONS 8. INSTALLING SINGLE TRANSMITTERS
5. TRANSFORMER INSTALLATION 6. APPLY POWER - SELECT DIALING METHOD
1
PLUG TRANSFORMER
INTO AN UN-SWITCHED
AC OUTLET
SECURE
TRANSFORMER
WITH SCREW 2
WHEN IT IS INSTALLED
WITH THE JUMPER SET
FOR INSTANT
IT WILL
FUNCTION
AS ACTIVITY
FOR DXS-31 STATIONARY TRANSMITTERS
WHEN IT IS INSTALLED
WITH THE JUMPER SET
FOR DELAY
IT WILL
FUNCTION
AS EMERGENCY
WHEN IT IS
INSTALLED
WITH THE
RIGHT BUTTON IT WILL ONLY
ACTIVATE
USING BOTH
BUTTONS
FOR ALL TWO-BUTTON TRANSMITTERS
WHEN IT IS
INSTALLED
WITH THE
LEFT BUTTON
IT WILL
ACTIVATE
USING
EITHER
BUTTON
FOR MODEL DXS-32: CUT JUMPER (INSTANT TX) FOR USE
AS AN ACTIVITY TX. SEE DXS-32 INSTALLATION INSTRUCTIONS
ADDS ONE TRANSMITTER AT A TIME
PRESS CANCEL BUTTON
FOR 5 SECONDS
• CONSOLE ANNOUNCES
THAT IT IS READY TO
LEARN TRANSMITTERS 1
2 ACTIVATE TRANSMITTER
• CONSOLE ANNOUNCES
TRANSMITTER TYPE THEN
REVERTS TO STANDBY MODE
NOTE: IF THE CONSOLE'S MEMORY
IS FULL, THE CONSOLE WILL ANNOUNCE
"ERROR ZONES FULL"
3 REPEAT STEPS 1 & 2 FOR ADDITIONAL
TRANSMITTERS (UP TO 16 TOTAL)
NOTE: PRESS CANCEL BEFORE TRANSMITTING TO RETURN
TO STANDBY MODE WITHOUT ENTERING A TRANSMITTER
• THE CONSOLE WILL ANNOUNCE ITS STATUS
THE CONSOLE WILL RETURN TO STANDBY MODE AUTOMATICALLY
WHEN A TRANSMITTER IS LEARNED OR AFTER 30 SECONDS
HAS ELAPSED
DXS-62A
NOTE: WRITE DOWN EACH TRANSMITTER'S TYPE AND ZONE NUMBER
WHEN THE TRANSMITTER IS ADDED. THE CENTRAL STATION WILL NEED
TO KNOW THE TYPE AND REPORTING ZONE FOR EACH TRANSMITTER.
SLIDE POWER
SWITCH ON
ON
IF REQUIRED, CHANGE THE DIALING METHOD BY PRESSING
AND HOLDING THE HOME & CANCEL BUTTONS FOR 3 SECONDS
WHILE SWITCHING THE POWER ON
• 7 BEEPS SOUND FOR PULSE DIALING
• 8 BEEPS SOUND FOR TONE DIALING
NOTE: THE DEFAULT DIALING METHOD IS TONE DIALING
OFF