NeoDigits.com NEUNEO MPEG4 - Manual (Page 10)

START TO USE THIS PLAYER
POWER ON THE PLAYER AND TV
Connect this player with your TV / PC Monitor / Projector, amplifier (if available)
and power source.
Turn on this player by click the power button on the front panel.
Turn on TV and switch it to the appropriate video mode ( composite video input,
S-video input or component video input ).
If you connect the TV via component video input and get no image on the TV
screen, please press “P-SCAN” button on the remote control a couple times until
the TV shows image.
If you get black/white image on the TV screen, click “PAL/NTSC” button on the
remote control to switch the player to the appropriate TV system ( PAL or NTSC).
You should be able to see the welcome screen on the TV by now.
1.
2.
3.
4.
5.
6.
ENTER SETUP MENU
Click “SETUP” button on the remote control.
You will see the general setup page show up on the screen.
1.
2.
--- General Setup Page ---
TV Display
Angle Mark
OSDLang
Captions
Screen Saver
Last Memory PS
On
Eng
Off
On
Off
-8-