Nextar NCD60C - Manual (Page 3)

LOCATION AND FUNCTION OF CONTROLS
SPECIFICATIONS
GENERAL
Supply Voltage
DC 12V. Negative Ground
Current Consumption Max.15A
Power Output 40W X 4 (Measured at DC 14.4V)
Unit Dimensions 178[W] X 165[D] X 50[H] mm.
FM SECTION
Frequency range
87.5MHz – 107.9MHz
Effective sensitivity 3uV.
I.F Frequency 10.7MHz.
AM SECTION
Frequency range
530KHz – 1710KHz
Effective sensitivity 40dB.
I.F Frequency 450KHz
RCA LINE OUT 1. RELEASE BUTTON
Output CD Max. 1200mV Press this button to eject the front control panel from the main body.
CD PLAYER
System
Compact Disc Audio System 2, 3 & 4. SEL BUTTON (Select) AND VOLUME (MENU) UP (+) / DN (–) BUTTONS
Suitable CDs CD, CD-R, CD-RW Disc a) Press the SEL button briefly to select each of the following modes:
Signal format Sampling frequency 44.1KHz VOLUME - > BASS - > TREBLE - > BALANCE - > FADER - >
No. of quantization bits 1bit When the desired audio mode is selected, press the + or – button to adjust the
Frequency characteristics 20Hz – 100Hz < 5dB value of that audio effect.
10KHz – 20KHz < 5dB. In each mode you have about 3 seconds to make your changes before the
S/N Ratio to CD 50dB [1KHz] display returns to the tuner (radio) or CDP mode.
Number of channels 2 STEREO channels. The different audio modes display the following numeric ranges:
- VOL : (MIN) 0 , 0 1 , . . . ...49, 63 (MAX) .
- BASS / TREB: - 7 , - 6 , . . . , 0 , . . . + 6 , + 7
- BAL : 1 0 L , 9 L , . . . , 0 , . . . 9 R , 1 0 R
- FAD : 1 0 F, 9 F, . . . , 0 , . . . 9 R , 1 0 R
Note: If you preselect a preset EQ (Preset Equalizer Curves), you cannot
change the BASS and TREBLE values.
b) Press the SEL button and hold it for more than 2 seconds to access the menu
mode. Now press the SEL button briefly to select from the following options:
EQ (OFF / FLAT / CLASS / ROCK / POP ) - > BEEP ON / OFF - > SEEK 1 / 2 - >
12 H / 24 H - > VOL LAST / ADJ .
DSP SETTINGS:
In EQ mode you can select from the equalizer settings DSP OFF, FLAT, CLASS,
ROCK and POP by pressing the + and – buttons.
BEEP ON / OFF :
Turn the confirmation beep on or off by pressing the + or – button .
BEEP ON: The confirmation beep can be heard whenever a button is pressed.
BEEP OFF: The confirmation beep is switched off.
Page 9 Page 2