NEC LT 100 - Manual (Page 36)

Using the Viewer function
If you use the Viewer function on the projector, you must first install
the optional LT Viewer board (VK-LT) in the projector and set up the
exclusive software included with the VK-LT kit.
See the user's manual included with the VK-LT for installing and
uninstalling the software.
Mounting the Optional LT Viewer Board
To install the Viewer board:
1. Switch off the main power and unplug the power cord. Turn the
projector so that the bottom is up.
2. Remove the screw from the board cover.
3. Place the board in place and secure it with the four screws supplied
with the VK-LT board.
4. Attach the two foot caps to adjust projector height. After complet-
ing, put the projector back in the original position.
69
OPERATION 70