Net Optics Link Aggregator Tap 10/100 In-Line to GigaBit with SFP Monitor Ports - Manual (Page 11)

10/100 In-Line Link Aggregator Tap
7
Note: ______________________________________________________________
The 10/100 Link Aggregator is shipped with the following default dip-switch
settings. It is strongly recommended that you do not make any changes to
these settings, except when needed, and only to switches 2,4,5 and 6. If Switch
3, for example, is toggled to "on," the Link Aggregator will not get a valid
link. In the event that the aforementioned occurs, it will be necessary to return
the dip-switches to the default states and to power-cycle the unit.
___________________________________________________________________
Figure 6: Default Dip-switch Settings
NOTE: To activate, push buttons UP.
(This diagram shows all segments
in the OFF position)
1 3 4 5 6 7 8 2
/
.
LINK
FAULT
ON
OFF
ON
OFF
ON
OFF
ON
OFF
FD
HD
ON
OFF
ON
OFF
10
100
RESERVED
ON
OFF
RESERVED
DUPLEX
AUTO
NEGOTIATION