Nikon XX152-02-00 - Manual (Page 17)

Installation of Optional In-Ceiling Mounting Kit
rveyorVFT fixed camera
dome can
(such
1. Install the
2. the 1.5-in. NPT pipe,
3.
4. When it becomes
5. Verify that each cable dro length.
6. Lift the camera mechanism up to the housing and attach the housing’s safety cord clip to the camera
mechanism’s tab. Allow the SurveyorVFT mechanism to hang from the housing. Refer to Figure 2.
7. Route each cable from the inside top its mating connector on the camera PC
Figure 3B
Indoor Pendant
The indoor pendant model mounts on a Vicon mount or a 1.5-in. vertical pipe with an appropriate coupling.
The pipe is a standard 1.5-in. NPT type and must be oriented vertically so the Su
effectively hang from the pipe. Be sure the area around the selected location is clear of obstacles
as steel beams, headers, pipes, electrical wiring, etc.) that would interfere with mounting. Video, sync,
and power cables must be routed to the location.
mount in accordance with the installation manual included with the mount or prepare the
vertical 1.5-in. NPT pipe.
Feed all necessary cables through the back of the mount or out the end of
approximately 15 in. (381 mm) in length.
Lift the housing up to the mount or pipe and feed the cables through its top opening.
Place the housing onto the 1.5-in. pipe and screw clockwise, looking up at the housing.
snug, turn it an additional quarter-turn.
ps from the pipe opening at least 15 in. (381 mm) in
of the housing down over to
board. Add 1 in. (25 mm) of extra length to each cable for termination (if not previously terminated) and
cut them. The approximate length of each cable should be 14 - 15 in. (356 - 381 mm).
Continue with the section on Cable Connections.
XX152-02-00 Rev 1004 SurveyorVFT Fixed Camera Dome Installation • 7