Neuton MA 3.0 - Manual (Page 17)

NEUTON MA 3.0 Cordless Electric Trimmer Safety & Operating Instructions 13
Advancing the Cord
Each time the Trimmer starts or comes to a complete
stop, the Trimmer’s cutting cord automatically advances
and cuts itself to the proper length.
You can also manually advance the cord.
1. Release the orange control bar to stop the Mower
or Power Pod.
2. Remove the safety key.
3. Push the white button on the side of the cartridge
housing and pull the cord to advance it (Figure 11).
The cord advances in small increments, so you might
have to press the button a few times.
Important: Try not to advance the cord too much.
If the cord is too long, the cutter on the Trimmer shield
automatically trims the length of the cord (Figure 12).
Tips for Using Your Trimmer
Following these tips will enhance the performance of your Trimmer:
■
Always stop the Mower before toggling the Mower/Auxiliary switch.
■
If you are using your Mower, you can adjust the cutting height of the Trimmer by raising or
lowering the Mower’s cutting height level. Make sure you first stop the Mower and remove the
safety key before changing the height.
■
Stop the Mower or Power Pod and remove the safety key before changing the position of the
Trimmer head or housing.
■
The battery runs down more quickly in edger mode. You can realistically expect up to 45
minutes of use in edger mode, and approximately one hour in trim mode. This is when having
an extra charged battery comes in handy. Be sure to remove the safety key when you change the
battery.
■
Be sure to clean the Trimmer head frequently, keep the cooling vents and air intake holes free
of debris.
WARNING! Be careful: the excess cord
will fly off when you start the Trimmer
and could be dangerous.
Figure 12. Manually advancing the cord
Figure 13. Automatically cutting the cord