Nextar XPJ - Manual (Page 21)

21
Maintenance
Care of the projector
Your projector needs little maintenance. The only thing you need to do on a regular basis is to keep the lens clean.
Never remove any parts of the projector except the lamp. Contact your dealer if other parts need replacing.
Cleaning the lens
Clean the lens whenever you notice dirt or dust on the surface.
λ Use a canister of compressed air to remove dust.
λ If there is dirt or smearing, use lens-cleaning paper or moisten a soft cloth with lens cleaner and gently wipe
the lens surface.
Never rub the lens with abrasive materials.
Cleaning the projector case
Before you clean the case, turn the projector off using the proper shutdown procedure as described in "Shutdown"
on page 15, and unplug the power cord.
λ To remove dirt or dust, wipe the case with the supplied cleaning cloth.
λ To remove stubborn dirt or stains, moisten a soft cloth with water and a neutral PH detergent. Then wipe the
case.
Never use wax, alcohol, benzene, thinner or other chemical detergents. These can damage the case
.
Storing the projector
If you need to store the projector for an extended time, please follow the instructions below:
λ Make sure the temperature and humidity of the storage area are within the recommended range for the
projector. Please refer to "Specifications" on page 22, or consult your dealer about the range.
λ Retract the adjuster feet.
λ Remove the batteries from the remote control.
λ Pack the projector in its original packing or equivalent.
Transporting the projector
It is recommended that you ship the projector with its original packing or equivalent. When you carry the projector
yourself, please use the original box or the soft carry case that is provided.