Numark Industries PRO TT-2 - Manual (Page 8)

PRO TT-2 Turntable
- The Leader in DJ Technology
©2000 Industries - 8 - http://www.numark.com
TONE ARM SETTINGS
The following explains proper counterweight and
anti-skating set up. Cartridge manufacturers usually
specify the proper settings.
a) Remove the stylus protector, do not touch the
stylus tip during the adjustment.
b) Set the cueing lever to the lower position so it
does not effect tone arm height.
c) Set Anti-skate adjustment to 0.
d) Place counterweight on the rear of the tone arm
e) Release the arm clamp and lift the tonearm from
the arm rest so it moves freely.
f) Rotate the counterweight until the tonearm is
approximately balanced horizontally (floats
freely).
g) Refasten the tonearm with the arm clamp.
h) Hold the
counterweight
stationary with one
hand and rotate only
the stylus-pressure
ring to bring the
number "O" of the
ring into alignment with the center line on the
tonearm rear shaft.
i) Rotate the counterweight with scale ring
clockwise to the
correct stylus pressure
following the
manufacturer's
recommendation.
Note: Failure to follow recommended stylus
pressure could damage both the stylus and
record. This can also seriously degrade
performance.
j) Set the anti-skating control knob to the same
value as the stylus pressure, unless your
manufacturer specifies otherwise.
LCD DISPLAY
29
30
31
32
33
29. Speed Indication
33 - 33 rpm
45 - 45 rpm
33 + 45 - 78 rpm
30. Speed Adjust Indication - This will display
adjustments in platter speed made by the pitch
control.
31. Play/Pause - Indicates current state of the platter
32. Pitch/Quartz - Indicates current mode of
operation
33. Platter Wheel - Simulates all actions of speed
and direction of the platter.