National Instruments Smart Camera - Manual (Page 8)

NI Smart Camera I/O Accessory User Guide 8 ni.com
Specifications
This section lists the specifications of the NI Smart Camera I/O Accessory. These specifications are
typical at 25 °C, unless otherwise noted.
Note Refer to the NI 17xx Smart Camera User Manual for specifications about signals.
Power Requirement
Supply voltage .......................................................24 VDC +20%/–15% (IEC 1311)
Current requirement ...............................................Refer to the specification for your NI Smart Camera
Physical
Dimensions ............................................................8.712 cm
× 8.509 cm × 4.445 cm
(3.43 in.
× 3.35 in. × 1.75 in.)
Weight ....................................................................98.1 g (3.46 oz)
Spring terminal blocks ...........................................6, 2 positions per block
Wire gauge .....................................................12–28 AWG wire
Camera connector ..................................................15-pin D-SUB male connector
RS-232 connector ..................................................9-pin D-SUB male connector
24VDC connector ..................................................15-pin D-SUB female connector
Environmental
The NI Smart Camera I/O Accessory is intended for indoor use only.
Operating temperature ...........................................0 to 55 °C
Storage temperature ...............................................–20 to 70 °C
Humidity ................................................................10 to 90%, noncondensing
Pollution Degree ....................................................2
Approved at altitudes up to 2,000 m.
Safety
The NI Smart Camera I/O Accessory is designed to meet the requirements of the following standards of
safety for electrical equipment for measurement, control, and laboratory use:
• IEC 61010-1, EN 61010-1
• UL 61010-1, CSA 61010-1
Note For UL and other safety considerations, refer to the product label, or visit ni.com/
certification , search by model number or product line, and click the appropriate link in the
Certification column.