NEC Express5800/120Rh-2 N8100-1126F User Manual
NEC Computers
Advertising
This manual is related to the following products:
Table of contents
Document Outline
- COVER
- SAFETY INDICATIONS
- SYMBOLS USED IN THIS USER'S GUIDE AND WARNING LABELS
- PREFACE
- ABOUT THIS USER'S GUIDE
- IN THE PACKAGE
- CONTENTS
- 1. Notes on Using Your Server
- 2. General Description
- 3. Setting Up Your Server
- 4. Configuring Your Server
- 5. Installing the Operating System with Express Setup
- 6. Installing and Using Utilities
- 7. Maintenance
- 8. Troubleshooting
- SYSTEM VIEWERS
- LEDS
- ERROR MESSAGES
- SOLVING PROBLEMS
- Problems with the Server
- Problems with Windows Server 2003 x64 Editions
- Problems with Windows Server 2003 R2
- Problems with Windows Server 2003 and Windows 2000
- Problems with NEC EXPRESSBUILDER
- Problems with Express Setup
- Problems with Master Control Menu
- Problems with Configuration Diskette Creator
- Problems with Disk Array Configuration
- COLLECTING EVENT LOG
- COLLECTING CONFIGURATION INFORMATION
- COLLECTING DR. WATSON DIAGNOSTIC INFORMATION
- MEMORY DUMP
- RECOVERY FOR Windows 2000 SYSTEM
- OFF-LINE MAINTENANCE UTILITY
- RESETTING THE SERVER
- FORCED SHUTDOWN
- 9. Upgrading Your Server
- A. Specifications
- B. Other Precautions
- C. IRQ
- D. Installing Windows Server 2003 x64 Editions
- E. Installing Windows Server 2003
- BEFORE INSTALLING WINDOWS SERVER 2003
- Optional Board Supported by NEC EXPRESSBUILDER
- Disk Array Controller (N8103-91)
- Installing Service Pack
- Updating System
- Re-installing to the Hard Disk Drive which has been upgraded to Dynamic Disk
- Manual Installation when N8103-80F/81F/86 and SCSI HostRAID Keeps Connection
- MO Device
- Partition Size
- About the Upgrade to Windows Server 2003 R2
- INSTALLING WINDOWS SERVER 2003
- DRIVER INSTALLATION AND ADVANCED SETTINGS
- PROSet
- Network Driver
- Re-install the Network Driver
- Graphics Accelerator Driver
- Installing SCSI Controller Driver (N8103-65F)
- Installing SCSI Controller Driver (N8103-75)
- Installing SCSI Controller Driver (N8103-56/-95/N8190-126)
- Installing Disk Array Controller Driver (N8103-80F/81F)
- About Windows Activation
- Available Switch Options for Windows Server 2003 Boot.ini File
- SETTING FOR COLLECTING MEMORY DUMP (DEBUG INFORMATION)
- BEFORE INSTALLING WINDOWS SERVER 2003
- F. Installing Windows 2000
- BEFORE INSTALLING WINDOWS 2000
- INSTALLING WINDOWS 2000
- DRIVER INSTALLATION AND ADVANCED SETTINGS
- PROSet
- Network Driver
- Re-install the Network Driver
- Graphics Accelerator Driver
- USB 2.0 Driver
- Installing SCSI Controller Driver (N8103-65F/75)
- Installing SCSI Controller Driver (N8103-56/-95/N8190-126)
- Installing RAID Controller Driver (N8103-80F/81F)
- Available Switch Options for Windows 2000 Boot.ini File
- SETTING FOR COLLECTING MEMORY DUMP (DEBUG INFORMATION)
- G. Product Configuration Record Table