Niles Audio WS100R - Manual (Page 8)

A voiding Interference
The WS100R is designed to work in most applications
including plasma displays and in areas where CFL lighting
and indirect sunight are present. You should avoid locating
the WS100R near potential sources of electrical or optical
noise, such as light dimmers or low-voltage lights.
A voiding Electrical Interference
A void locating the WS100R near any potential sources of
electrical or optical noise, such as light dimmers, low-volt-
age lights, and neon lights.
A voiding Optical Feedback
If installing the WS100R in the same r oom as an IR flasher,
it is possible for the flasher’s IR output to be picked-up by
the WS100R. This effect, known as an optical feedback
loop, can cause erratic operation. Optical feedback is
similar to acoustical feedback: the howling or whistling
sound heard in a P.A. system when the microphone is too
close to the speaker. To avoid optical feedback:
1. Re-position the flasher(s) and/or the sensor.
2. Use Niles MF1or MF2 flashers and cover them with the
supplied IR blockers.
Changing the Color of the WS100R
The Decora-style inser
t on the WS100R is removable,
allowing fast and easy color changes as needed. Inserts are
available in a variety of colors.
If you need to change the color of the WS100R:
1. Obtain the WS100R Decora-style insert in the desired
color from your Niles dealer.
7
W A L L - M O U N T I N F R A R E D S E N S O R
F igure 3
Removing the
Decora-style Insert
“TECH TIP”
Do not exert
excessive pressure
on the plastic
mounting tabs.
DS00331ACN/WS100R 1/8/04 9:47 AM Page 9