Nortel Networks Passport 4400 - Manual (Page 101)

T1/E1 and Digital Voice Modules Passport 4400 Hardware Installation Manual
9-7
DVEM Power Harness
For Passport 4400 units containing one or two Digital Voice Expansion Modules,
a DVEM power harness must be installed. The power harness provides additional
power to the DVEM boards (see Figure 9-9).
The DVEM power harness must be ordered separately – please consult document
900-1959-20, Passport 4400 Ordering Catalog. The part number of the harness is
NTAU32AA.
Note: Do not connect the DVEM power harness to the T1/E1 Voice
Module. If your Passport 4400 contains only one DVEM, there will
be an additional, unused connector on the power harness (this
connector would normally plug into a second DVEM). In this
case, leave the spare connector unconnected.
Figure 9-9. DVEM Power Harness
To Power Sharing
Board
Do Not Connect
Harness to TVM/EVM!
TVM/EVM
DVEM
Rear
(Back Panel)
Front View
TVM = T1 Voice Module
EVM = E1 Voice Module
DVEM = Digital Voice Expansion Module
To DVEM