Nexgrill 720-0033 - Manual (Page 11)

O TEST
he pipe that goes to the
o leak from any or all
nly those parts recommended by the manufacturer
arranty he grill until ave
CHECK FOR LEAKS AFTER
T
Make sure all control valves are in the “OFF” position.
Turn the gas supply on. Check all connections from the
L.P. cylinder up to and including the connection to the
manifold pipe assembly (t
burner). Soap bubbles will appear where a leak is
present. If a leak is present, immediately turn off gas
supply, tighten any leaking fittings, turn gas on, and
recheck. Should the gas continue t
of the fittings, turn off the gas supply, and contact our
customer service at 1-800-913-8999.
O
should be used on the grill. Substitution can void the
w
. Do not use t all connections h
been checked and do not leak.
ALWAYS
EVERY L.P. TANK CHANGE
Check all gas supply fittings for leaks before each use. It
is handy to keep a spray bottle of soapy water near the
shut-off valve of the gas supply line. Spray all the
fittings. Bubbles indicate leaks.
Disconnected L.P. cylinders must have threaded valve
plugs tightly installed, must not be stored in a building,
garage or any other enclosed area.
The gas must be turned off at the supply cylinder when
the unit is not in use.
If t e appliance is stored indoors the cylinder must be
h
disconnected and removed from the appliance. Cylinders
mu t be stored outdoors in a well-ventilated area out of
s
the reach of children.
to shipment
urners
excessive noise
bris, spider webs, etc.
Gas flow check:
Each grill burner is tested and adjusted at the factory prior
make it necessary to adjust the burners. The flames of the b
Flames should be blue and stable with no yellow tips,
air shutter or burner ports are blocked by dirt, de
; however, variations in the local gas supply may
should be visually checked.
or lifting. If any of these conditions exist, check if the
INSTALLER FI
ˆ Specified clearance maintained 24” from
combustibles.
All internal packaging rem
NAL
oved.
.C.
L.P. gas. Gas connections to grill using hose &
hut off valve location.
NS
CHECK LIST
regulator assembly provided (pre-set for 11.0” water
column).
Unit tested and free of leaks.
ˆ
ˆ Knobs turn freely.
ˆ Burners are sitting properly on orifices.
Pressure regulator connected and set for 11.2” W ˆ
ˆ
ˆ User informed of gas supply s
USER, PLEASE RETAIN THESE INSTRUCTIO
FOR FUTURE REFERENCE.
10