Nilfisk-Advance America NILFISK AX 310 - Manual (Page 24)

B-10 / ENGLISH
B-10 - FORM NO. 56041672 - AX 310
TROUBLESHOOTING
If the possible causes listed below are not the source of trouble, it is a symptom of something more serious. Contact your Nilfi sk Service Center
immediately for service.
TRIPPING THE CIRCUIT BREAKER
The Circuit Breaker (D) is located on the Control Panel; it protects the electrical circuit and brush motor from damage due to overload conditions. If the
circuit breaker is tripped try to determine the cause.
Brush Circuit Breaker (3 Amp) Possible cause may be:
1 Debris wrapped around the brush drive (remove debris)
2 Electrical short circuit (have your Nilfi sk Service Center or qualifi ed electrician check the machine)
Once the problem has been corrected, push the button in to reset the circuit breaker. If the button does not stay in, wait 5 minutes and try again. If the
circuit breaker trips repeatedly, call your Nilfi sk Service Center for service.
POOR WATER PICKUP
Possible causes may be:
1 Recovery Tank Full (empty recovery tank)
2 Recovery hose is kinked or damaged (replace the hose)
3 Recovery tank dome lid gasket leak (replace gasket)
4 Debris caught in vacuum shoe or recovery hose (clean vacuum shoe and recovery hose)
INADEQUATE SOLUTION FLOW
Possible causes may be:
1 Solution tank empty (fi ll solution tank)
2 Solution lines or screen clogged (fl ush lines and screen)
TECHNICAL SPECIFICATIONS (as installed and tested on the unit)
Model AX 310 AX 310 J
Model No. 56265302 56265303
Voltage/frequency V/Hz 220-240 / 50-60 100 / 50-60
Rated Current Amp 3.5 6.7
Protection Class (electrical)
Protection Grade
IP34 --
Sound Pressure Level IEC 60335-2-72: 2002 Amend. 1:2005, ISO 11201 dB (A)/20μPa 76 75
Total Weight lbs/kg 67 / 30 67 / 30
Vibrations at the Hand Controls (ISO 5349-1) m/s 2 0.87m/s 2 0.87m/s 2
Solution Tank Capacity 5 gal (19l) 5 gal (19l)