National Instruments Measure Data Acquisition User Manual
Page 58
Appendix B Error Codes
© National Instruments Corporation
B-5
Measure Data Acquisition User Manual
-10244
deviceInitErr
The driver encountered a hardware-
initialization error while attempting to
configure the specified device.
-10245
osInitErr
The driver encountered an operating-
system error while attempting to perform
an operation, or the operating system
does not support an operation performed
by the driver.
-10246
communicationsErr
The driver is unable to communicate
with the specified external device.
-10247
DSPcmosConfigErr
Possible reasons for this error are as
follows.
•
The CMOS configuration-memory
for the device is empty or invalid.
•
The configuration specified does not
agree with the current configuration
of the device.
•
The EISA system configuration is
invalid.
-10248
dupAddressErr
The base addresses for two or more
devices are the same; consequently, the
driver is unable to access the specified
device.
-10249
intConfigErr
The interrupt configuration is incorrect
given the capabilities of the computer or
device.
-10250
dupIntErr
The interrupt levels for two or more
devices are the same.
-10251
dmaConfigErr
The DMA configuration is incorrect
given the capabilities of the
computer/DMA controller or device.
-10252
dupDMAErr
The DMA channels for two or more
devices are the same.
-10253
jumperlessBoardErr
The driver is unable to find one or more
jumperless devices that you have
configured using
WDAQCONF.EXE.