NetComm N150 - Manual (Page 24)

NetComm Liberty Series 3G Wireless N150 Wireless Router YmL1�WN YmL1�WN 1�WN
4 www.netcomm.com.au
Advanced Routing
This page allows you to configure static and dynamic routing rules for your 3G Router.
Advanced Routing – Static
Static Routing allows computers that are connected to your 3G Router to communicate with computers on another LAN segment which
are connected to it via another router. to set a rule, you need to specify the following:
• Destination
• Sub Netmask
• Gateway
• Interface
Advanced Routing – Dynamic
Dynamic Routing uses the RIP protocol to allow the 3G Router to adapt to changes in the network. RIP enables the device to determine
the best route for each packet based on the “hop count” or number of hops between Source and Destination. To enable Dynamic Routing,
select Enable from the dropbox and click Apply.
DHCP Client
this page allows you to view the current DHCP client of your 3G Router.