Nortel Networks 1000M - Manual (Page 108)

108 Mounting the chassis
Note: For a CS 1000M Chassis system, the Signaling Server must
be mounted in an external 480 mm (19 in.) equipment rack. Refer to
Signaling Server Installation and Commissioning (NN43001-312) for
information on installing the Signaling Server hardware.
WARNING
If the Small System requires earthquake bracing, you must
install the chassis on a wall in a vertical position. Refer to the
earthquake bracing requirements in the chapters on system and
site requirements in Communication Server 1000M and Meridian
1 Small System Planning and Engineering (NN43011-220) and
"Bracing against earthquakes" (page 63) .
WARNING
A chassis is 13.5 kg (30 lb) with circuit cards installed. A chassis
is 12 kg (26 lb) without circuit cards installed. Get help lifting the
chassis if necessary.
Mounting in a 480 mm (19 in.) rack/equipment cabinet
Items required
To install the chassis in a 480 mm (19 in.) rack/equipment cabinet, you
require the following items:
• equipment layout plan
• one left chassis guide bracket
• one right chassis guide bracket
• one left ear bracket
• one right ear bracket
• eight #12-24 self-tapping screws
• four #8-32 machine screws
The NTTK09 contains all of the above items, with the exception of the
equipment layout plan.
Note: The Chassis system does not include the 19-inch rack/equipment
cabinet.
Refer to Figure 42 "Typical layout for installing the chassis in a
rack/equipment cabinet" (page 109) for guidelines on how to position
system components.
Nortel Communication Server 1000
Communication Server 1000M and Meridian 1 Small System Installation and Commissioning
NN43011-310 01.04 Standard
Release 5.0 13 May 2008
Copyright © 2008, Nortel Networks
.