NEC PlasmaSync 50MP2 - Manual (Page 14)

7
POWER/STANDBY
LUME UP INPUT SELECT
/EXIT LEFT/— RIGHT/+
Approx.
7m/ 23ft
Using the wired remote control mode
Connect the supplied remote cable to the remote control’s
remote jack and the “REMOTE CONTROL” terminal on
the monitor.
When the cable is connected, the mode automatically
switches to wired remote control. When the wired remote
control mode is used, the remote control can be operated
even if no batteries are loaded. Operating Range
* Use the remote control within a distance of about 7 m/
23ft. from the front of the monitor’s remote control sensor
and at horizontal and vertical angles of up to approximately
30°.
* The remote control operation may not function if the
monitor’s remote control sensor is exposed to direct
sunlight or strong artificial light, or if there is an obstacle
between the sensor and the remote control.
Handling the remote control
• Do not drop or mishandle the remote control.
• Do not get the remote control wet. If the remote control
gets wet, wipe it dry immediately.
• Avoid heat and humidity.
• When not using the remote control for a long period,
remove the batteries.
• Do not use new and old batteries together, or use different
types together.
• Do not take apart the batteries, heat them, or throw them
into a fire.
• When using the remote control in the wireless condition,
be sure to unplug the remote cable from the REMOTE
CONTROL terminal on the monitor.
SPEAKERS MUST HAVE MORE THAN 7WATT RATING IMPEDANCE 6 OHM
RIGHT LEFT EXTERNAL
CONTROL
REMOTE
CONTROL
CONTROL
LOCK
ON / OFF
RGB 3 ( D i g i t a l RGB )
RGB 1
R / CR / PR
L ( MONO )
VIDEO 1
L ( MONO )
G / Y
B / CB / PB
HD
VD
R
VIDEO 2
VIDEO 3
R
Y
CB / PB
CR / PR
L ( MONO )
R AUDIO 2
DVD1
/HD1
AUDIO 3
AUDIO 1
RGB2
/DVD2
/HD2
EXTERNAL
CONTROL
CONTROL
LOCK
ON / OFF
REMOTE
CONTROL
Remote Control
Cable
To Remote Jack